Download ST62T10 Datasheet
Transcript
ST6210B, 15B, 20B, 25B IINTERRUPTS (Cont’d) 3.4.3 Interrupt Option Register (IOR) The Interrupt Option Register (IOR) is used to enable/disable the individual interrupt sources and to select the operating mode of the external interrupt inputs. This register is write-only and cannot be accessed by single-bit operations. Address: 0C8h — Write Only Reset status: 00h 7 - 298 SET GEN LES ESB CLEARED SET CLEARED SET CLEARED Enables all interrupts Disables all interrupts (Except NMI) Rising edge mode on Port A Falling edge mode on Port A Level sensitive mode on Port B & C Falling edge mode on Port B & C 0 LES ESB GEN - - - - Bit 7, Bits 3-0 = Unused. Bit 6 = LES: Level/Edge Selection bit. When this bit is set to one, the interrupt #1 (Port A) is low level sensitive, when cleared to zero the negative edge sensitive interrupt is selected. Bit 5 = ESB: Edge Selection bit. When this bit is set to one, the interrupt #2 (Port B and C) is positive edge sensitive, when cleared to zero the negative edge sensitive interrupt is selected. Bit 4 = GEN: Global Enable Interrupt. When this bit is set to one, all interrupts are enabled. When this bit is cleared to zero all the interrupts (excluding NMI) are disabled. When the GEN bit is low, the NMI interrupt is active but cannot cause a wake up from STOP/WAIT modes. This register is cleared on reset. 38/68 Table 5. Interrupt Options 3.4.4 External Interrupt Operating Modes The NMI interrupt is associated with the external interrupt pin. This pin is falling edge sensitive and the interrupt pin signal is latched by a flip-flop which is automatically reset by the core at the beginning of the non-maskable interrupt service routine. A Schmitt trigger is present on the NMI pin. The user can choose to have an on-chip pull-up on the NMI pin by specifying the appropriate ROM mask option (see Option List at the end of the Datasheet). The two interrupt sources associated with the falling/rising edge mode of the external interrupt pins (Port A-vector #1, Port B & C - vector #2) are connected to two internal latches. Each latch is set when a falling/rising edge occurs during the processing of the previous one, will be processed as soon as the first one has been serviced (unless a higher priority interrupt request is present). If more than one interrupt occurs while processing the first one, the subsequent ones will be lost. Storage of interrupt requests is not available in level sensitive detection mode. To be taken into account, the low level must be present on the interrupt pin when the MCU samples the line after instruction execution. At the end of every instruction, the MCU tests the interrupt lines: if there is an interrupt request the next instruction is not executed and the appropriate interrupt service routine is executed instead. When the GEN bit is low, the NMI interrupt is active but cannot cause a wake up from STOP/WAIT modes.