Download Board Support Package ModARM9 for Windows

Board Support Package ModARM9 for Windows CE 5.00
7.9
JTAG Booster
This tool from FS Forth-Systeme GmbH gives the user the possibility to copy the
boot loader much faster to the onboard Flash. Before storing a new boot loader
to the ModARM9 modules, the JTAG Booster hardware have to be connected to
the target board. Connect the JTAG Booster to the parallel port of your host PC
and the other end to JTAG connector on the target board.
jtag2410 /pnand a9m2410.bin /lpt-base=378 /driver=1
jtag2440 /pnand a9m2440.bin /lpt-base=378 /driver=1
Start from your host PC the JTAG2410.exe/JTAG2440.exe tool to program the
boot loader. For more details please refer to the JTAG Booster documentation.
Set the switch S2 to 1-ON and the rest OFF. Than power up the target and start
the tool on your PC. When the boot loader is successfully downloaded remove
the power from the target and switch back 1-OFF. Power up the target and over
the serial port, as described in the previous chapters, you should see the starting
of the boot loader.
Note: The thick strand on the JTAG Booster connector indicates ground
and is pin 2. Pin 1 is connected to the square pad on the target board and
is marked with a triangle.
27