Download A12E-G2121 Front

Transcript
EonStor S16E-R1240/G1240 Installation and Hardware Reference Manual

Immediate replacement: When a PSU fails, it should ideally be
replaced immediately. Do not remove the PSU module unless a
replacement is readily available. Removing a PSU without a replacement
will cause severe disruptions to the internal airflow and the system will
overheat, possibly causing irreparable damage to some of the system
components.
WARNING!
Although the system can operate using a single PSU module, it is not
advisable to run the EonStor subsystem with a single PSU module for an
extended period of time.
5.5.2 Replacing the PSU Module
To replace a PSU, please follow these steps:
Step 1.
Power off the PSU. The power switch is located on each
PSU’s rear-facing panel. (See Figure 5-6)
Step 2.
Disconnect the power cord that connects the PSU to the
main power source.
Step 3.
Loosen the retention screw that secures the extraction
handle to the chassis using a Phillips screwdriver. See below
drawing for its location.
Figure 5-6: PSU Parts Identification
Step 4.
5-12
Remove the PSU module by pulling the extraction handle
upwards. The extraction handle should gracefully disconnect
the PSU from the backplane connectors. Once dislodged,
gently pull the PSU module out of the system. If the system is
Replacing a Faulty PSU