Download VHDL Models for Board-level Simulation

Transcript
WSM/SH/010 Issue 1
1
INTRODUCTION
1.1
Purpose and scope
5
european space agency
This document provides recommendations for development and usage of VHDL models
intended for board-level simulation. This document is intended to be read together with
the VHDL Modelling Guidelines, RD1. It could be used in ESA developments of models
for board-level simulation and for simulation of board designs comprising such models.
The information herein is not to be considered as requirements, although sometimes
expressed as such, but merely as useful hints and recommendations.
The purpose of these recommendations is to define modelling criteria that will produce
models for board-level simulation that are highly accurate in both functionality and
timing, and that will provide sufficient simulation performance to facilitate long
simulation runs. The document also provides sufficient information to allow someone
with little VHDL knowledge to perform a simulation of a board design using models for
board-level simulation.
Parts of the document, such as the discussion on model verification, can also be used for
ASIC developments. Requirements on models for board-level simulation and VHDL
models used for synthesis are dissimilar and therefore are no synthesis aspects discussed
in this document. The document does not address distribution of models for board-level
simulation nor the protection of design information, issues which are discussed in “The
Usage of VHDL in the European Space Agency”, RD6.
This document is not intended to be a guide to the VHDL language itself. On the contrary
is the reader expected to have previous VHDL knowledge before developing a model
intended for board-level simulation.
1.2
Document organisation
This document is divided in five major parts, the first one covering the definition and
benefits of board-level simulation, followed by guidelines for developing models for
board-level simulation. The third part covers the verification of these model, and is
followed by a description on how to model and verify a board design. The final part
specifies requirements on model documentation.
For each requirement or suggestion stated in the document there is normally an
accompanying explanation and often a code example or a figure. All code examples in the
document have been taken from a complete model for board-level simulation, although
the VHDL code may sometimes have been reduced to highlight the essential parts. The
code examples are therefore not always possible to be analysed by a VHDL simulator as
presented. A complete model is not included in the document due to the prohibitive size
of the source code, but is made available via ftp as described in section 1.3.