Download GRASS 4.2 Reference Manual Section VI

Transcript
Example rain gauge data input files:
______________________________________________________
one gauge
|two gauges
______________________________________________________
00
|
00
103
|
111 data for gauge 1
20
|
10
|
257
35
|
22
|
-1 ———— delimiter
559
|
00
674
|
156 data for gauge 2
1000 |
104
______________________________________________________
This step will prompt to determine if multiple rain gauges are to be used. If so, it will prompt for the name of a map that
represents areas to be assigned to the given gauges. The number of categories and their value should match the number of
rain gauges. Next the program prompts for the name of the rain gauge data file. The program reads the file and displays
what it found to the screen for approval. Having this, it will create the appropriate ANSWERS input files.
Step 6 Identify outlet cell
Map input: none
Other input: row and column number of watershed outlet element
Description: ANSWERS needs to know the row and column number of the element at the watershed outlet. To facilitate
your finding this information, the raster map [project name].ELEMENT has been created. The category values of this map
are the sequentially numbered cells of the watershed. The category descriptions are the cell’s row and column number. Using
a tool such as d.what.rast, the row and column number of the outlet cell can be queried from the displayed element map.
Step 7 Specify areas with subsurface drainage
Map input: Areas with subsurface drainage (optional)
Description: This step offers a menu which allows the delineation of 1) all the watershed with subsurface drainage, 2) none
of the watershed with subsurface drainage, or 3) areas with subsurface drainage specified with a raster map (all elements with
a value greater than zero will be input to ANSWERS as having subsurface drainage. Note: the drainage coefficient for
areas with subsurface is set with the other soils parameters in step 2. If “all” or “none” of the watershed is simulated as
having subsurface drainage, no input map is required; otherwise a raster map is used to specify areas with subsurface
drainage.
Step 8 Catalogue channel parameters
Map input: Channels
Other input: Channel width and roughness coefficient for each category of channel
Description: Watershed cells with a well-defined channel should be defined to ANSWERS. ANSWERS assumes the
channel is rectangular in cross-section and is sufficiently deep to handle runoff.
To prepare channel data for use with ANSWERS, the following is needed: a raster map layer of the channels in the watershed and a description of width (meters) and roughness (Manning’s “n”) for each channel category found in the layer.
It is suggested that the aspect map from Step 4 b created in conjunction with the map, since ANSWERS will abort operation
if a one channel element does not flow directly into another adjacent channel element.
Step 9 Define channel slopes
Map input: Channel slope
Description: An optional input to ANSWERS is the slope of channels. If a channel slope input is not given, ANSWERS
assumes the slope for the channel is the same as the overland slope for the element.
If desired, a raster map may be used to define channel slope values. To do so, a raster map should be prepared with category
values for channel slopes in tenths of a percent (i.e. a category value of 31 would indicate a channel slope of 3.1 percent).
Note: Even though channel slopes are an optional input to ANSWERS, this step must be run if only to say no map will be
used.
7