Download operation manual

ENGLISH
OPERATION MANUAL
 Connect the cables to the new OSRAM “Sirius HRI 280W E20.6” lamp
Important: ONLY use an original “Philips MSD Platinum 2R” lamp, other lamps could result in less
performance or even damage the unit.
 Place the new lamp on the support by pressing it until the two metal supports maintains correctly the lamp.
 Switch the unit back on and use a DMX controller to point the open beam on a wall.
Attention: avoid looking at light coming directly from the lamp inside the unit, the UV-radiation of the lamp
is harmful for your eyes. (The light of the beam passes through a UV-filter first)
 You will see a hotspot in the beam projected on the wall. Adjust this hotspot using the screw as shown in
Fig. 6. The hotspot should be as much as possible in the center of the beam.
Figure 6 - Hotspot correction screws
 Close the cover
 Done
BRITEQ®
6/23
BTX-TITAN