Download SH7060 E8000 Hitachi Debugging Interface User`s Manual

• Power on the host computer.
• Check that the area selected in the [Computer Properties] dialog box are displayed as [System
Reserved] in the list.
The next step prevents the memory area for the PC interface board being accessed by another
program. Modify the CONFIG.SYS file. Use the SYSEDIT program to edit the file.
• Select [Run] from the [Start] menu.
• Type SYSEDIT and click [OK]. The SYSEDIT will start.
When EMM386.EXE is used in the CONFIG.SYS file, the CONFIG.SYS file must be modified.
If the CONFIG.SYS file is not used, or if EMM386.EXE is not used even when the CONFIG.SYS
file is used, go to the following procedure and modify the SYSTEM.INI file.
• Locate the line in the CONFIG.SYS file that reads:
device=C:\WINDOWS\EMM386.EXE RAM
• Change the line so that it reads as shown below.
device=C:\WINDOWS\EMM386.EXE RAM X=aaaa–bbbb
Here, aaaa is the upper four digits of [Start value] and bbbb is the upper four digits of [End
value]. For example, for the switch set to 6, you would set the line to read:
device=C:\WINDOWS\EMM386.EXE RAM X=D800–DBFF
•
Save the CONFIG.SYS file.
The following is about modifying the SYSTEM.INI file.
• Add the following line to the [386Enh] section in the SYSTEM.INI file:
EMMExclude=aaaa-bbbb
Here, aaaa is the upper four digits of [Start value] and bbbb is the upper four digits of [End
value]. For example, for the switch set to 6, you would set the line to read:
EMMExclude = D800-DBFF
• Save the SYSTEM.INI file and exit the SYSEDIT.
• Restart the host computer.
Setting Up the PC Interface Board on Windows NT® 4.0: The description given below is about
®
setting up the PC interface board on Windows NT 4.0.
11