Download SR-430

6.Connection to Computer
6. Connection to Computer
SR-430 is available to connect either RS-232C or USB to the Computer.
The Computer is recognized USB interface, In case of both of cable connected to Computer.
Connection status
Only USB is connected.
USB
RS-232C
Available
N/A
N/A
Available
Available
N/A
Only RS-232C is connected.
USB & RS-232C are connected.
Connect the device to a computer by referring to the following procedure.
(1) Connection to Interface cable
This deveice is able to connect USB interface or RS-232C interface.
Please choose a cable which much as interface connector.
* RS-232C is needed to straight cable for connect between SR-430 and Computer.
Please set the following settings even if you use either USB initerface or RS232-C initerface.
(2) Setting data transfer rate
Set the same data transfer rate (baud rate) to this device and the computer. The device is set at
9,600bps by default. Before switching turning SW1, be sure to turn the power of the device off.
When setting the baud rate of the computer, refer to its operation manual.
The baud rate is set using 0 to 4 of SW1.
(* refers to the default setting)
Switch position
Baud rate
0
2,400
1
4,800
2
9,600
3
19,200
4
38,400 ＊
(5 to 9 are not used)
SW1: Sets baud rate.
SW1 SW2 DIPSW
SW3
Paper ream weight
Baud
rate
Density level
Setting
1~F
-22-
2
1 2 3 4 5 6 7 8