Download Appendix A - Diagnostica

Chapter Three Installation
Chapter Three
Installation
3.1 Operating environmental requirements
a)
b)
Environment temperature range：+5℃～+40℃
Relative humidity range：≤80%
c)
d)
Atmosphere pressure range：70kPa～106kPa
Power supply: a.c.100V～240V,50Hz±1Hz/60Hz±1Hz
When using, avoid strenuous vibration, keep it away from devices with high field, intense
magnetic field or high voltage; avoid strong sunlight blazing down on the display; keep the device
well-ventilated, moisture proof and dustproof.
3.2 Unpacking inspection
After unpacking, check the device according to "Packing List" and install it according to
requirements and methods described in "Installation" after affirm that there is no shipping
damage.
Warning
If there is breakage at unpacking check, it is banned to use the device to ensure security.
Warning
The probe should be protected from felling off or crashing and the manufacturer assumes no
responsibility for this kind of hazard.
3.3 Installation
1. Check the power supply too see if it is in the expected range, then connect the equipment and
the power socket with the cable.
2. A 96-core connector is used for electronic convex array probe (see figure).
3. Connection of 96-coreconnector. First, switch the locker on the probe connector to “OPEN”,
position the connector localization pin with the hole on the socket, then plug in the connector
and switch the locker to “LOCK”. When the locker is moved to “OPEN”, unplug the
connector to remove the probe from the main unit.
Locker
LOCK
connector
Localization pin
OPEN
Socket
Localization hole
96-core probe connection sketch
10