Download Manuals - OMEGA Engineering

DBK209
The DBK209 is a mini-adapter board suitable for both analog
and digital expansion. The board provides three DB37
connectors (P1, P2, and P3).
DBK209 connects to DaqBoard/2000 Series P4 connector
via a CA-195 cable.
Other than the form factor, DBK209 is identical to DBK201.
•
•
•
P1 is used for ANALOG I/O.
P2 is used for DIGITAL I/O.
P3 is used for Pulse/Frequency (Digital and
Counter/Timer) I/O.
DBK209’s P4 (100-pin connector) connects to a
DaqBoard/2000 Series board’s P4 connector via a
CA-195 cable.
DBK209
P4-to-P1/P2/P3 Mini-adapter Board
Pinouts for DaqBoard/2000 Series Boards
Reference Notes: You must set up DaqView for the particular DBKs in your system. If you
are unfamiliar with the method of setting up DBKs in DaqView, or if you need a refresher,
refer to the following documents as needed.
➣ The DBK Set Up in DaqView chapter of the OMB-DBK Option Cards Modules User’s
Manual (p/n OMB-457-0905),
➣ The OMB-DBK Option Cards Modules User’s Manual (p/n OMB-457-0905), for the
applicable DBK document module(s). The documentation discusses hardware
configuration aspects that require setup in software.
➣ The DaqView document module.
During software installation, documentation is automatically installed onto your hard drive
as a part of product support. The default location is the Programs directory, which can be
accessed through the Windows Desktop.
Note: As new DBKs become available, be sure to use the latest revision of DaqView with the proper
configuration options.
&$87,21
Do not confuse connectors. Ensure that you only connect P1 I/Os to P1,
P2 I/Os to P2, and P3 I/Os to P3. Improper connection may result in equipment
damage.
The following P1, P2, and P3 connector pinouts pertain to the DBK200 Series adapter boards that were
discussed in the first part of this chapter. P1, P2, and P3 are subset connectors of the 100-pin P4 connector
found on the DaqBoard/2000 Series boards, and for that reason P4 pin-correlation is provided.
Note: In the pinouts that follow, some pins are irrelevant to certain DaqBoards. For example:
DaqBoard/2002 and /2004 have no P1 correlation; and for those boards, P1 and the associated P4
pins should be ignored. The DaqBoard/2003 only relates to P3 and the associated P4 pins; but for
DaqBoard/2003, a DBK205 screw-terminal adapter is typically used (see page 2-3). Note that
chapter 1, Device Systems and Device Overviews, contains detailed information that is specific to
each board.
OMB-DaqBoard/2000 Series User’s Manual
07-26-02
System Connections & Pinouts
2-7