Download View/Open - Lirias
Transcript
AutoCAD tips for surveying with TheoLt 1. Use viewports to see the whole and the part. 2. Use plan world to check the orientation has worked ok 3. Use layers to separate work by day, station, and surveyor. 4. Freeze off layers you don’t need : it is always worth the time taken to get a clear view of where you are working 5. 3D views will let you keep a check on heights 6. Don’t panic- TheoLt will always plot in the draw tab: if you can see the data from the instrument in the command line- provided you have a line command to catch the points! 7. Remember you can zoom in on detail and draw with a polyline snapped through the measured points to get smoother lines if needed. 8. Watch out for filedia it will need to be reset to 1 from time to time: use the customised ‘F’ button to re-set it when the saveas dialog fails. 9. Remember to open your AutoCAD drawing before you open TheoLt: you won’t be able to map anything without a drawing open! Moving the Total Station around the building (inside and outside): Before moving the Total Station to a new position, you need to measure all you instrument positions, this manual explains how to use the “Orientation to Reference” feature built in Theolt to orientate your system. 1. Go to the tab Control and hit the control icon; 3. Either “snap to the point”, or easier go to the “Stn List” button on the Instrument Position and select where your device is leveled; 4. When the “Theolt: Select Station” appears, select your position; 2. Go to the tab “Orientation to Reference”; 5. On windows “Theolt: Station Instrument H..” press OK 6. Insert the Instrument height that you have measured to the floor; Architectural Heritage Recording Manuals 40