Download View/Open - Lirias

Transcript
AutoCAD tips for surveying with TheoLt
1. Use viewports to see the whole and the
part.
2. Use plan world to check the orientation
has worked ok
3. Use layers to separate work by day,
station, and surveyor.
4. Freeze off layers you don’t need : it is
always worth the time taken to get a clear
view of where you are working
5. 3D views will let you keep a check on
heights
6. Don’t panic- TheoLt will always plot in
the draw tab: if you can see the data from the
instrument in the command line- provided
you have a line command to catch the points!
7. Remember you can zoom in on detail
and draw with a polyline snapped through
the measured points to get smoother lines if
needed.
8. Watch out for filedia it will need to be reset
to 1 from time to time: use the customised
‘F’ button to re-set it when the saveas dialog
fails.
9. Remember to open your AutoCAD
drawing before you open TheoLt: you won’t
be able to map anything without a drawing
open!
Moving the Total Station around the building
(inside and outside):
Before moving the Total Station to a new
position, you need to measure all you instrument
positions, this manual explains how to use the
“Orientation to Reference” feature built in Theolt
to orientate your system.
1. Go to the tab Control and hit the control icon;
3. Either “snap to the point”, or easier go to the
“Stn List” button on the Instrument Position and
select where your device is leveled;
4. When the “Theolt: Select Station” appears,
select your position;
2. Go to the tab “Orientation to Reference”;
5. On windows “Theolt: Station Instrument
H..” press OK
6. Insert the Instrument height that you have
measured to the floor;
Architectural Heritage Recording Manuals
40