Download Manuel Anglais

Section 17: Operation of your Codec
Gain in use, expressed
as a percentage of total
gain available
Gain Indicator
bar – moves
from left to
right to visually
indicate a gain
setting
Input being
adjusted – either
Local or Remote
Input On/Off
Indicator
-69%---Local1----Off
»»»»»»»»»»»»»
<< Left
Right >>
On
Off
Exit
1
2
3
Press SOFTKEY 1 to turn
input on or SOFTKEY 2 to
turn input off
4
Press
SOFTKEY 4
to exit the
Figure 46: Local and Remote Input Level Control LCD Screen
17.4.
Channel On/Off and Channel Lockout
Channels can also be switched on and off by pressing the Audio Select button
below each PPM meter momentarily when viewing the main connection screen.
This on/off switching is controlled by the On/Off Lockout menu which is
accessed via [Menu] > [Configuration] > [System Settings] > [On/Off Lockout].
If this mode is disabled (default) then a user can turn a channel on or off simply
by pressing the appropriate button under each individual PPM meter. The
channel level screen is only displayed after a 1 second wait (or the menu will
appear faster if you press a SOFTKEY and turn the MENU SELECTOR while
holding the button in.)
If On/Off Lockout mode is enabled then a user must bring up the channel level
screen and use the appropriate SOFTKEY to turn the channel on/off (SOFTKEY
1 or SOFTKEY 2 respectively). With the mode enabled the channel level screen
is displayed as soon as a PPM button is pressed.
17.5.
Adjusting Auxiliary and Phone Input Levels
The incoming level of the auxiliary and phone inputs can be adjusted using the
Audio menu via SOFTKEY 1.
17.5.1. Auxiliary Input Levels
To adjust the incoming level of the auxiliary input select SOFTKEY 1 Audio
and then select [Aux Vol/Ctrl] > [Disable Remote Control →Yes←]. The
LCD screen on the codec changes to display a screen similar to the one used
to adjust inputs on the COMMANDER G3 rack unit codec.
Tieline
TECHNOLOGY
Page 115