Download Installing the WRIA

158
3521
3522
3523
3524
3525
3526
3527
3528
3529
3530
3531
3532
3533
3534
3535
3536
3537
3538
3539
3540
3541
3542
This same shapefile should be used every time the model is run since it is updated with
the temperature data for the selected nodes. The shapefile used must have the same
formatting as the Temp_Flags_Warnings.shp file, or the model will not run successfully.
Select DO Flags and Warnings Shapefile
U
The model also writes DO data, flags and warnings to a shapefile. This shapefile and its
selection process are nearly identical to the Temperature Flags and Warnings Shapefile
described above. A default DO Flags and Warnings shapefile exists and should be used
for all model runs. The data in this shapefile is overwritten each time the model runs.
The shapefile is named DO_Flags_Warnings.shp. To select this shapefile, press the
browse button
to the right of the DO Flags and Warnings Shapefile pathname box.
This will bring up the screen shown below.
If the DO Flags and Warnings shapefile has already been added as a layer, it can be
selected from the loaded layers list as shown above. Otherwise, click the From file radio
button and enter the pathname or press the browse button
Point Shapefile form as shown below.
WRIA-1 DSS User’s Manual
to bring up the Open