Download FPD Touch Monitors Installation Guide

Transcript
Chapter 1 Introduction to Flat-Panel Displays
19
Using Other Video Resolutions
The native and intended resolution for the MicroTouch 12.1" Profile
and ChassisTouch monitors is 800 x 600 (SVGA).
The 12.1" FPS monitor also supports the DOS text mode resolution of
720 x 400. This resolution is appropriate if you are running a DOS
touch application.
The 12.1" FPD monitor provides support for 640 x 480 (VGA)
resolution, but only for compatibility and monitor setup. The monitor
does not properly display the image at VGA resolution. However,
many video cards initially display a screen image at the VGA
resolution. By providing minimal support for 640 x 480 resolution, the
monitor can display the desktop controls that let you change to the
optimal resolution of 800 x 600.
Comparing Video Resolution on a CRT
The CRT is an analog device. There are no discrete points on the
screen that constitute a pixel. Instead, a CRT has a smooth phosphor
surface inside the tube. CRT technology uses an electron beam to
stimulate the phosphor surface to emit light and display an image. The
location of points on the screen is determined by the coordinate system
in which the electron beam is working — not by physical constraints
used on the front surface of the display. As a result, a CRT can
display different resolutions without compromising image quality.