Download Manual

To connect the External NMEA to the serial Port 2 see the following picture:
POWER SUPPLY
- +
1
POWER & I/O
POWER & I/O CABLE
PIN
1
2
5
7
WIRE COLOR
BLACK
RED
GRAY
BROWN
EXTERNAL
FUNCTION
PWR-/GND/COMMON
POWER INPUT+ (10-35 Vdc)
OUTPUT 2+
INPUT 2+
NMEA
COMMON
DEVICE
RX+
TX+
Fig. 2.4.3b - External NMEA Connections on Port 2
To choose your preferred setting follow the procedure:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 2 INPUT" + 'ENTER'
Then choose your preferred setting among the NMEA available settings NMEA 1200N81-N, NMEA 4800-N81-N, NMEA 4800-N82-N, NMEA 9600-O81-N, NMEA 9600-N81N (the default setting is 4800-N81-N) and press 'ENTER' to confirm.
2.4.4 C-COM CONNECTIONS
To connect the modem C-COM to the chart plotter follow the procedure:
1. Connect Power & I/O as follows:
POWER & I/O CONNECTOR/CABLE
POWER & I/O
PIN CABLE COLOR FUNCTION
1
2
3
4
5
6
7
8
BLACK
RED
WHITE
GREEN
GRAY
YELLOW
BROWN
BLUE
PWR-/GND/COMMON
PWR+ (10-35 Vdc)
Used by C-COM
Used by C-COM
OUTPUT 2+
Used by C-COM
INPUT 2+
OUTPUT EXTERNAL ALARM+
Fig. 2.4.4 - C-COM Connection
Note
The connection is valid for the C-COM IR and C-COM RS232 too.
2. Into the Input/Output menu, set the C-COM for Port 1 as follows:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 1 INPUT" + 'ENTER' + "C-COM" + 'ENTER'
Also the modem C-COM can be connected to the other Ports, in this case set the
format for the selected Port.
2.4.5 EXTERNAL ALARM CONNECTION
To connect the External Alarm device see the following picture:
User Manual
25