Download Manual

4.2.1.3 Goto
Place cursor on Mark
Press 'DEST': a circle encloses the Mark symbol. A straight line is shown on the
screen connecting the Target with the ship's position. When the Target is placed, all navigation data are referred to this Target.
4.2.1.4 Moving Mark
Select Advanced Mode + Place cursor on Mark
Press 'ENTER'. Select "MOVE" and press 'ENTER'. Move the cursor by the cursor key, a dotted line connecting the Mark with the new position is shown:
Fig. 4.2.1.4 - Moving Mark function (I)
Press 'ENTER':
Fig. 4.2.1.4a - Moving Mark function (II)
The Mark is placed in the new position, the "old" Mark, remains on the screen
shaded until the screen is redrawn.
Note
If you try to move a Mark that belongs to many routes, the chart plotter emits three beeps and on the screen a Warning
message appears. If you want to move the Mark, press 'ENTER'.
4.2.1.5 Editing Mark
Select Advanced Mode + Place cursor on Mark
User Manual
71