Download NASGRO v7.0 Release Notes

•
Corrected "write all data" behavior in Examine/Edit pane to prevent writing of extraneous
data values at end of file when switching between multiple material IDs.
•
Corrected issues with the User and NASA toughness check boxes on the Toughness
Notes page. Checkboxes may only search one file at a time, and only display "Edit/Enter"
data when the user has permission to edit that file.
•
On the Toughness Notes page, some searches were listing entries, but not displaying
them when "Show Selected Data" or "Enter/Edit Data" were chosen. This has been
corrected to properly show all data that matches the filter criteria.
•
On the Toughness notes pages, selecting some specimen types were displaying a different
number of matches than shown when viewing the matches on the "Enter/Edit" or "Show
Selected Data" page. This has been corrected, and the number of specimen types that can
be used to filter the results expanded.
•
Pressing the "Enter/Edit Data" button on the Toughness Notes page would bring up a
superfluous pop-up stating "Please Enter a data ID". The pop-up has been removed.
•
The Toughness Notes page was unable to open the user toughness data file. This has been
corrected.
•
The Toughness Notes pages would display erroneous numbers when selecting a filter
criteria when no ID had been selected. This has been changed to properly display "0".
•
NASMAT's utilization of the Windows Registry to store some user specific data has been
changed to use an initialization file instead. NASMAT no longer utilizes the Registry.
•
Removed NASMAT's reliance on shared memory when executing nasmat.dll, and
replaced it with a file pipe. This change simplifies the coding required for future changes,
as well as fixes occasional issues caused by the shared memory not creating properly.
•
Fixed an issue where modifying selection criteria on the Toughness Notes pages would
not modify the displayed data to match the modified criteria, or would not display data at
all.
•
Resolved multiple issues where NASMAT would not properly plot material ID's when
using the "New Curvefit/Plot" button with only plot checkboxes selected. (b.1373,1383,
1400)
•
For ID: Q3LP18AB1, the ultimate tensile strength was corrected to 205 ksi, and the yield
strength was changed to 180 ksi, after verification. (b.1378)
21