Download (User`s) Manual.
Transcript
OPERATING INSTRUCTIONS P Proceed/Continue from Breakpoint 4.6.13 Proceed/Continue P This command is used to proceed or continue program execution without having to remove assigned breakpoints. This command is used to bypass assigned breakpoints in a program executed by the G command. NOTE Refer to example program shown on page 4-16 for the following P command example. Breakpoints have been inserted at locations $0105 and $0107 (refer to example on pages 4-16 and 4-17). Example: >G 0100<CR> Start execution at 0100. P-0105 Y-DEFE X-F4FF A-44 B-FE C-D0 S-0047 Breakpoint encountered at 0105. Continue execution. >P<CR> P-0107 Y-DEFE X-F4FF A-44 B-FE C-90 S-0047 Breakpoint encountered at 0107. > M68HC11EVBU/D 4-27