Download 4 - EOS Research, Ltd.

Transcript
ProView 2.1x User’s Guide
__________________________________________________________
Analog Inputs
In the second column below the heading Analog or Discrete Inputs are shown the enabled analog inputs.
Analog inputs can also be configured as simple discrete inputs. Below the tagname is another LED. This
LED behaves in a similar fashion to those for discrete inputs; it is gray when the input is not “active”, and
green or red when it is in the active state (see the definition for Active State in the ProControl User Manual).
A small bar graph provides a visual indication of the value of the analog input. At the left and right ends of
the bar graph are numbers that represent the lower and upper limits, respectively, of the analog input values
(corresponding to 4 and 20 mA). In this case FLOW_1 has been set up with a range of 0 to 200 GPM.
Below the bar graph is a numerical representation of the current value of FLOW_1.
Discrete Outputs
On the right side of the screen below the heading Discrete Outputs are shown the enabled discrete outputs,
corresponding to the relay outputs in the ProControl. In this site configuration there are 11 outputs. Above
the tagname of the output is either a virtual “Toggle Switch” or lamp/button representation. By its position
and/or its color it shows the state of discrete output: if the switch is left-leaning and gray the output is
“OFF”; if the switch is right-leaning and green then the output is “ON”.
Discrete outputs can be configured as an alarm lamp or button when this would be more appropriate. If the
lamp/button appears gray then the output is “OFF”. If the lamp/button appears red or green then the output is
“ON”.
Your system may also have Extended Outputs, which are located on a panel behind the discrete outputs. To
access these outputs, point your mouse at the words Discrete Outputs at the top of the column and click the
left mouse button.
FYI
Regardless of what the discrete outputs look like in ProView, they all behave the same way on the
ProControl itself – namely, the associated relay output is energized when the output is ON.
__________________________________________________________
8
8100\pv215man\pv215man