Download PRISM 3000

Transcript
Figure 2-1
PRISM 3000 Rear Panel
DC Version
ON
2A
250 V
OFF
DCV RET GND
1
2
3
AC Version
110 /220 VAC
1.0A
.4A /.2A
ETHERNET
ALARM
RELAY
l
PORT 4
PORT 3
PORT 2
PORT 1
NMS
IN
O
NMS SUPV STA
OUT
CLK
NC C NO GND
4
5
6
7
8
T1
DTE
T1
NET
9 10 11 12 13
14
Index
Control/Indicator
1
DC Power Switch
This switch turns the DC power ON or OFF.
2
DC Fuse
This DC fuse is rated at 2.0 Amp.
3
DC Connection
48 VDC power is connected to ‘DCV’; the return is connected to ‘RET’. See Section 2.11.2 on page 2-6.
4
AC Connection
This 110/220 VAC power receptacle is rated at 50-60 Hz, 0.6 A / 0.3 A. See Section 2.11.1 on page 2-6.
5
AC Fuse
This AC fuse is rated at 1.0 Amp and is shipped with a spare.
6
AC Power Switch
This switch controls the AC power (position I is ON and position O is OFF).
7
Alarm Relay
The ‘Normally Closed’ alarm connects to NC & C. The ‘Normally Open’ alarm connects to NO & C.
8
NMS
This is the network management system input/output. Refer to Section 2.10.1 on page 2-4.
9
SUPV
Supervisory port connection. Refer to Section 2.10.2 on page 2-4.
10
Station Clock
The N x 56/64 kHz or 1.544 MHz external station clock connector. Refer to Section 2.9 on page 2-3.
11
T1 DTE
The T1 DTE port for drop and insert applications. Refer to Section 2.6 on page 2-3.
12
T1 NET
The T1 network port. Refer to Section 2.7 on page 2-3.
13
Slot 1 - Ethernet
This is the 15-pin Ethernet or Token Ring connection. Refer to Section 2.10.3 on page 2-5.
14
Ports 1 through 4
Two cards with up to two ports each may be inserted into each of these slots. Ports 1 and 2 show a combination of V.35 and EIA530 cards.
2-2 Installation
Function
PRISM 3000