Download CE Marking Gloves

FOR PROTECTIVE GLOVES, MOTORCYCLE BOOTS AND OTHER PROTECTIVE CLOTHING
FOR PROTECTIVE GLOVES, MOTORCYCLE BOOTS AND OTHER PROTECTIVE CLOTHING
GUIDE FOR MANUFACTURERS
GUIDE FOR MANUFACTURERS
should be replaced immediately.
iv)
the size of the boots according to EN 13634:2010,
LIFETIME AND CARE INSTRUCTIONS: Under normal conditions, and without damage, these boots should
continue to provide protection for up to 3 years.
v)
year of manufacture and at least the month,
vi)
Category II,
DISPOSAL: In general, boots are classified as household consumables. They must be placed in a dedicated
space according to local regulations.”
vii)
the standard number EN 13634:2010,
6)
viii)
the motorcycle use symbol and the characteristics in the order of Abrasion resistance, Impact cut
resistance, and Transverse rigidity (indications Level X, Level Y and Level Z),
ix)
the symbols: IPA for boots providing impact resistance, IPS for boots meeting the shin protection
requirements, WR for boots meeting water protection requirements, FO for boots resistant to fuel oil, SRA,
SRB or SRC for slip resistant boots and B for boots with water vapour permeable uppers,
x)
The care symbols:
Quality management system
Solid Boots Ltd. Pakistan, operates a Quality Manager System according to ISO 9001, certified by Quality
Certifications Ltd., Berlin. In summary, the Quality Plan comprises the following:
Item
Activity/process
Procedure
No.
Inspection
point No.
Person responsible
1
Material/component purchase
QMP-05
Purchasing Department
2
Material reception inspection
QMP-06
3
Cutting
QMP-07
4
In-process inspection
QMP-08
5
Stitching and size
QMP-09
6
Final inspection
QMP-10
7
Packing
QMP-11
Packing Department
8
Storage
QMP-12
Storage Supervis or
9
Distribution/shipping
QMP-13
Export Department
QMI-06
Quality Control Department
Production Departm ent
QMI-08
Quality Control Department
Production Department
QMI-10
Quality Control Department
The symbols shall be shown separately from the CE marking information, however. The following shows the label
attached to each boot.
Solid Boots Ltd.
Type 28061959
Size 42
The ISO 9001:2008 certificate from Quality Certifications Ltd., Berlin, is inserted here.
7)
2013/01
Compliance with the PPE Directive 89/686/EEC
Category II
The products covered by this Technical File address the following clauses in Annex II of Directive 89/686/EEC:
1.1
Design principles
1.2
Innocuousness of PPE
1.3
Comfort and efficiency
1.4
Information supplied by the manufacturer
2.2
Parts of the body enclosed use of absorptive materials
Level X Y Z
IPA, IPS,WR, FO, SRA, B
2.12 PPE bearing one or more identification or recognition marks directly or indirectly relating to health and
safety declaration of no dangerous substances provided and inclusion of mechanical protection symbols
3.1
Protection against mechanical impact
3.3
Protection against physical injury (abrasion, perforation, cuts and bites) bite protection does not apply
The packaging shall also be marked with the above information
Compliance with these provisions is demonstrated by applying harmonized European Standard EN
13634:2010.with EC type-examination performed by Notified Body WXYZ, 3210.
9)
8)
This section will contain all test reports as received from the Notified Body.
Product marking
Test reports
Solid Boots Ltd. bonded leather motorcycle boots are marked, on the label, with:
10)
I)
the CE marking symbol, indicating conformity with the PPE Directive 89/686/EEC,
This section will include the EC type-approval certificate issued by the Notified Body.
ii)
identification of the manufacturer,
iii)
manufacturer's type designation,
Page 6
Product type approval certificate
Page 7