Download Jewel (Tech) - RJ Mobility

15.6 Inspection
Each controller acts as a diagnostic system and if a fault is detected the battery gauge will
flash to a pre-determined sequence.
Control Dynamic DL Controller
The three colour illuminated display onthe top surface of the DL Controller acts as both a
fuel gauge and a warning gauge. When all lights are on the batteries are fully charged. As
the power is used the green lights and then amber lights will go out. When only the red
lights are left on the batteries will require recharging. If a fault is detected the illuminated
display will flash. To determine the fault count the number of flashes and refer to the
following table:
1
2
3
4
5
6
7
Low battery
High battery
Left Motor
Right Motor
Left or Right Park Brake
Controller fault
Motor stalled or joystick
out of neutral/time out
You may need to charge your batteries
Possible charger fault
There may be a fault or a loose connection
There may be a fault or a loose connection
There may be a fault or a loose connection
Please contact Customer Services Switch the controller off then back on again
Control Dynamic DX System
The three colour illuminated display on the top surface of the DL Controller acts as both a
fuel gauge and a warning gauge. When all lights are on the batteries are fully charged. As
the power is used the green lights and then amber lights will go out. When only the red
lights are left on the batteries will require recharging. If a fault is detected the illuminated
display will flash. To determine the fault count the number of flashes and refer to the
following table:
1
2
3
4
5
6
7
8
9,10
11
12
Limp Mode
Accessory Fault
Left Motor
Right Motor
Left Park Brake
Right Park Brake
Low Battery
Over Voltage
Limp Mode
Motor stalled or joystick
out of neutral/time out
Module Mismatch
Turn the controller off & then on again
Possible remote joystick fault
There may be a fault or a loose connection
There may be a fault or a loose connection
There may be a fault or a loose connection
There may be a fault or a loose connection
You may need to charge your batteries
Check the battery circuit for loose connection
Turn the controller off & then on again
Switch the controller off then back on again
Check the compatibility of modules
-33-