Download PROGRAM MANUAL_Rev5

Instructor Station
Revision 5
Via the NETWORK tab the following can be done:
5
-
Start network computers remotely – REMOTE START:
The network computers information is to be inputted into the “PCList.txt” file. Please input
as follows:
COMPUTER 1
0D00795F397E5
192.168.0.9
255.255.255.0
7
COMPUTER 2
[MAC Address]
[IP Address]
[Subnet mask]
[Port No.]
[…]
 Choose whatever name you want
 MAC address of the computer’s LAN card
 IP address of the computer
 Subnet mask
 Port number. Important when accessing from outside a network
router (you should enable this port in the router). This setting is not
important when running all computers and the Instructor Station in a
local network.
Here is an example:
COMPUTER ONE
0019DB6BA4FD
192.168.0.2
255.255.255.0
7
COMPUTER TWO
00805A62C8B6
192.168.0.3
255.255.255.0
7
Note that the format shown above needs to be respected (no dashes between digits in the
MAC addresses, no blank lines between computers, etc.).
Once this file is set up, the list of computers should appear in the Instructor Station
Network Computers window. By selecting a computer and clicking "Start selected
computer", the selected computer should start up. Also, by clicking on the "Network
maintenance (s/u all computers)" all the computers on the list will be started up.
IMPORTANT NOTE: Remote computer start up will work if:
1) The network card of each computer supports this feature (typically referred to as "Wake
On LAN").
2) If the network card/BIOS of each computer is appropriately configured to work in this
way.
30-Jun-2014
Page 21 of 65