Download UM1818 User manual - STMicroelectronics

UM1818
3
Hardware installation
Hardware installation
Connect a regulated dual DC power supply to the power source pins of the connector J3 as
described previously and power the board.
In order to download the firmware, plug the programmer adapter (Figure 5) in the
programming connector J1 and the IAR J-Link programmer in the JTAG connector of the
adapter.
Refer to the chapter firmware description (paragraph 6.3 for the firmware download
procedure). As soon as the application is launched, the LEDs should quickly switch on
indicating that the board has to be configured.
DocID026935 Rev 2
7/47
47