Download GX Developer Version7 Operating Manual

3 MELSAP-L PROGRAM EDITING METHOD
MELSOFT
3.12.10 Listing contacts/coils used
This operation lists where the specified devices are used in the operation
outputs/transition conditions and block information.
The symbols displayed represent the following.
"Step"
• S:n = Used as the operation output of step n.
• TR:n = Used as transition condition n.
"Sequence step"
• a = Used as the block start end bit of the applicable block.
• t = Used as the step transition bit of the applicable block.
• c = Used as the continuous transition bit of the applicable block.
• s = Used as the block pause/restart bit of the applicable block.
• m = Used as the pause mode bit of the applicable block.
• r = Used as the number of active step registers of the applicable block.
The operation method is the same as in the ladder mode.
For details of the operation method, refer to the GX Developer Operating Manual.
3.12.11 Searching for the device use status
This operation lists how the devices are used device-by-device (e.g. X, Y, M, D).
A device search also covers devices used in the block information, and if they are used
in the block information alone, they are shown as being used as contacts.
The operation method is the same as in the ladder mode.
For details of the operation method, refer to the GX Developer Operating Manual.
3.12.12 Changing the T/C set values
This operation changes the set values of the timers/counters used in the operation
outputs inside the block being displayed. (The T/C set values in different blocks cannot
be changed at the same time.)
The operation method is the same as in the ladder mode.
For details of the operation method, refer to the GX Developer Operating Manual.
3 - 46
3 - 46