Download Manual - KeyTalk

Transcript
19.2.2.1.
HwSig Verification settings
HwSig (see section 18.2 'Hardware Signature’) verification settings allow for the optional
configuration of HwSig verification for the specified service.
By default the HwSig verification is set to ‘Off’.
Figure 68: Hardware Signature verification setting
Select “CHANGE” to change the HwSig setting.
Two other options are available for the HwSig verification:

DevId:
Obtain the user’s HwId from our DevId product solution.

Exit:
Obtain the user’s HwId using the settings of the authentication module.
For the option ‘Exit’, in the case of Sqlite Module, the HwSig is obtained from the user’s
Hardware Signature field.
When the ‘DevId’ option has been chosen, make sure that the DevId Host & Port, as well
as Group Name and Group password are properly set.
Figure 69: Editing Hardware signature settings for a specific service
NOTE:
The HwSig verification is considered a failed login, thus the user is not issued a
certificate when:
61