Download User / Service - Avery Dennison

Manual
TTX 300/COBRA Online
Option: Dispenser
Connect the foot pedal to the plug on the back of the printer.
The rewind disk has 2 positions: raised and lowered. Make sure the disk is in the
lowered position. If necessary, push down on the disk to adjust it.
Remove enough labels to expose 1 ft / 40 cm of backing paper.
Thread the liner according to the following diagrams. Tighten liner by rotating the
rewind disk.
Each activation of the foot pedal will dispense one label. One or more blank labels
may dispense before printed labels are available.
Remove rewound liner periodically by pulling out the metal clip and sliding the liner
off the shaft.
Note: By defining the Punch Offset in the label format, the position of the label at the
dispensing edge may be varied. The length defined via Punch Offset must be
regarded as a non-printing area.
Ribbon
Printed
See detail on
following page
Metal Clip
Liner
Foot Switch
03/02
Rev. 1.11
31