Download "user manual"

Transcript
GB
5
Keep the plugs of Fig. 15 Ref. 1 and Ref. 3
together with the user manual.
Screw down the fitting integral to the low
pressure pipe on the service low pressure
valve Fig. 15 Ref. 2.
INSTALLING THE EVAPORATING
(AERATOR) UNIT
The evaporator unit may be installed in either of
two ways:
• using the ventilation holes (ventilation
portholes) already present on the vehicle.
• opening a new hole.
5.1 Using the ventilation port
This solution can be applied on condition that
the porthole measures 395x395 mm.
First remove the porthole after having taken out
the screws which fasten it to the roof of the
vehicle.
Scrape away all the sealing material located
around the opening Fig. 17 Ref. 1 and suitable
close the holes of the screws and the joint lines
using silicone or putty of a kind easily available
in specialized shops Fig. 17 Ref. 2.
Every kind of scrap,
glue, silicon, liners and so on should not be
disposed of within the environment, but
should be put in special containers and
delivered to Collection and Disposal Centres.
Fig.15
Screw down the nut integral to the high
pressure pipe on the fitting Fig 15 Ref. 4
which is located on the service high
pressure valve Fig. 15 Ref. 5.
Hold the fitting Fig. 15 Ref. 4 still by means
of the suitable wrench.
You will get a connection as shown on Fig.
16
Fig. 17
Fig. 16
12