Download "user manual"

GB
5.2 Opening a new hole
Place a reinforcing frame (Fig. 19) along the
profile of the opening.
On the roof, chose an central area between two
stanchions and use a felt pen to mark off a
square measuring 395 mm on each side Fig.
18 Ref. 1.
Use a small saw to carefully cut the opening on
the roof. Be careful not to cut any electric wires
Fig. 18 Ref. 2.
Wear goggles and safety
gloves before using any electrical tools or
manual saws.
Fig. 19
5.3 Positioning the evaporating unit
Before positioning the evaporating unit on the
roof of the vehicle, you must spread a proper
amount of slow-drying sealant around the
edges of the opening. Put the evaporating unit
onto the roof of the vehicle and place it over
the opening, previously treated with the
sealant. Make sure that the side holes (which
are on the bottom) Fig. 20 Ref. 1 face the
driving direction of the vehicle,
Fig. 18
Fig. 20
13