Download Control system EnergyLogic Wireless control Touchline

Transcript
User Manual Roth EnergyLogic Touchline/Wireless
Commissioning and operation
7.3
7.3.1
Change setpoints
Set room temperature
The wireless room thermostat is in stand-by mode.
► Press any button on the wireless room thermostat for 2 seconds.
► The display changes into operation mode. The setpoint blinks.
► Press sensor button
or
► Press sensor button
to confirm the new setpoint.
, to change the setpoint.
– If no sensor button is pressed, then the new setpoint will be automatically saved after 5 seconds.
– To interrupt this procedure press the sensor button
point will not be saved.
. The new set-
► If no sensor button is pressed, the wireless room thermostat returns into
stand-by mode.
7.3.2
Set floor temperature
The setting of the floor temperature is only available for the type with IR floor
temperature measurement.
The wireless room thermostat is in stand-by mode.
► Press any button on the wireless room thermostat for 2 seconds.
► The display changes into operation mode. The room temperature setpoint
blinks.
► Press sensor button
shows P01.
5 seconds to enter the user menu. The display
► Press sensor button
. The display shows P02.
► Press sensor button . The display shows the setpoint for the floor temperature and the symbol .
► Press sensor button
or
, to change the setpoint.
► Select one of the following options:
– Press sensor button
P03.
to confirm the new setpoint. The display shows
– Press sensor button , to interrupt the procedure. The new setpoint is
not saved. The display shows P02.
– If no sensor button is pressed, the wireless room thermostat returns into
stand-by mode after 1 minute. The new setpoint is not saved.
► To leave the user menu press sensor button
operation mode.
P10009989 A
. The display shows the
51