Download USER MANUAL TELESTO Printer

SET PARTIAL CUT DISTANCE
Synopsis:
ASCII
Hexadecimal
Decimal
Operand:
Value Decimal
Description:
Note:
Set partial cut distance for MH/MCTP mechanism (NVRAM).
US
ETX
LF
n
1F
03
0A
n
31
3
10
n
n
0
1
2
3
4
= Value for MH/MCTP mechanism :
0 steps
8 steps
16 steps ( Default )
24 steps
32 steps
Allows regulating the partial cut.
This command will store the cut distance setting in non-volatile memory (NVRAM).
This command must be followed by a reset.
SET PRE-HEATING MODE
Synopsis:
ASCII
Hexadecimal
Decimal
Operand:
Value Decimal
Default
Set Print head pre – Heating mode (NVRAM).
US
ETX
VT
n
1F
03
0B
n
31
3
11
n
n
0
1
0
= Mode selection
Disabled
Enabled
0≤n≤1
00 ≤ n ≤ 01
Limit:
Dec:
Hex:
Description:
Note:
This command will store the print-head pre-heating option in non-volatile memory (NVRAM).
When this mode is enabled, the controller monitors the print-head temperature and keeps it above 19-24°C.
If the temperature is around 0°C and the preheating is not active, the preheating will be automatically start
until the temperature will be around 19-24°C. After the preheating will become not active again.
This command must be followed by a reset.
TELESTO Printer User Manual
page 76 / 84
PDF created with pdfFactory trial version www.pdffactory.com
Ref. : 31 08271
Issue : Z