Download Genset Control

Manual 37392
easYgen-1000 - Genset Control
Chapter 2.
Navigation / Operation
1
5
2
6
12
3
7
4
8
13
9
10
11
14
Figure 2-1: Front panel and display
Figure 2-1 illustrates the front panel/display, which includes push buttons, LEDs and the Liquid Crystal display
(LC display). A short description of the front panel is given below.
NOTE
This push button is ALWAYS active and will stop the engine when pressed.
Function blocks
Buttons that have the same function within one screen are grouped into function blocks. The
function blocks are defined as:
Display .........Change the method of voltage and power calculations displayed (page 18).
Mode ............Change the mode of operation (page 20).
Operation ....Used to perform manual operation of the genset (page 21).
Navigation ...Navigation between system and configuration screens, and alarm list (page 21).
1
2
3
5
6
7
8
9
10
11
12
Push buttons
The push buttons on the front panel are assigned to softkeys on the display. Each softkey is assigned to a function depending on the mode of operation.
Liquid Crystal Display (LC display)
The display contains softkey characters, measuring values, modes of operation, and alarms. The
functionality of the display screens as well as the description of the functions is detailed in the
"Navigation" section (page 9).
13 14
LED
The left LED 13 indicates that the unit is in STOP mode. The right LED
messages are active / present in the control unit.
Page 8/38
14
indicates that alarm
© Woodward