Download Electronic load combination using the NOVA

Please read this manual carefully before starting to use the Autolab LED
Driver kit
The next sections deal with appearance and use of the equipment and contain
necessary information regarding operation and installation.
SAFETY PRACTICES
General
•
•
•
•
The following safety practices are intended to ensure safe operation of the
equipment and must be observed during all phases of operation, service
and repair of the instrument.
Failure to follow these instructions may cause unsafe operation.
Metrohm Autolab is not liable for any damage caused by not complying
with the safety requirements.
Failure to follow these instructions may void any warranty provided to this
product.
Electrical hazards
•
•
•
•
To avoid electric shock hazard, always ground the equipment by using the
provided power adaptor.
There are no user-serviceable parts. Equipment installation, component
replacement and internal adjustments must be done only by qualified
personnel.
Opening the equipment poses a risk of exposure to potentially dangerous
voltages.
Please also refer to the Electrical Hazards described separately for the
Autolab instrument used.
General precautions
•
•
•
Use only stable surfaces for setting up the system.
Do not look directly at the light coming out of the light source.
Allow the light source to cool down after prolonged used at high driving
currents.