Download RTD Input Module Type AJ65SBT2B

Transcript
PROGRAMMING
1
This chapter describes the programming procedure, basic programs for reading/writing
data, and program examples for the AJ65SBT2B-64RD3.
When applying any of the program examples introduced in this chapter to the actual
system, make sure to examine the applicability and confirm that no problems will occur in
the system control.
For the master module, refer to the user's manual of the master module used. For the
remote register, refer to Section 3.5. For the details on the dedicated instructions, refer to
the Type AnSHCPU/AnACPU/AnUCPU/QCPU-A (A Mode) Programming Manual
(Dedicated Instructions).
2
3
Programming Procedure
Create programs for executing temperature measurement in the AJ65SBT2B-64RD3 in
the following procedure.
4
PROCEDURES AND
SETTINGS BEFORE
OPERATION
Start
Conversion enable/disable setting
5
Measurement range setting
Initial setting
PROGRAMMING
Disconnection detection upper/lower limit
selection flag setting
Averaging processing setting
TROUBLESHOOTING
6
Measured temperature value read
End
APPENDIX
Figure 5.1 Programming procedure
INDEX
5.1
OVERVIEW
PROGRAMMING
SYSTEM
CONFIGURATION
CHAPTER5
SPECIFICATIONS
5
5.1 Programming Procedure
5-1