Download BWTTM System Installation Guide

April 2004
Installing and Orienting
the Junction Box
Before placing the BWT transducer into the FSPA/FWPA Buffer
permanently, you must make sure the preamplifier junction box will
be properly oriented once installed.
Note: The following drawings show the FSPA Buffer only.
1. Screw the transducer into the junction box as shown below.
2. Screw the transducer/junction box assembly into the FSPA/FWPA
Buffer.
3. Check the junction box orientation. The junction box lid should be
at a downward angle so water can drain. If it is not, adjust the
junction box until it does.
OK
Good
Bad
4. Remove the transducer/junction box assembly.
5. Repeat the above steps for the other transducer.
Installing Non-Flanged FSPA/FWPA BWT Buffers and Transducers
4-3