Download GFK-1883_SeriesSixPa..

Transcript
7
Real Time Consultants Pty Ltd
(Proprietary Information)
The bootldr utility will respond with a signon message and a prompt similar to the following:
RTC Boot Monitor version 1.28, May 9 2002
Entering boot monitor, type help for help
BootLdr>
BootLdr help Command
To get help on the available commands type:
BootLdr>?
The bootldr utility will respond with the following brief help on commands.
BootLdr> ?
Help
? or help
Print this message
reset
Reset the target board
boot [<baud>]
Boot a target processor (optional baud)
baud <baudrate>
Set new baudrate
exec
Execute a procedure file
md <start> [<end>]
Memory display
mm <start addr>
Memory modify
ferase <device> <sector>|<sector-sector>|all Erase FLASH sector(s)
go <addr> <stack> [term] [baud] Execute from specified HEX address
upload <dev> <st> <end> <file>
Upload from target FLASH to binary file
rupload <st> <end> <file> Upload from target RAM to binary file
download <dev> <st> <end> <file> [<file offset>] Download bin file to tgt FLASH
rdownload <st> <end> <file> [<file offset>] Download bin file to tgt RAM
verify <dev> <st> <end> <file> [<file offset>] Verify FLASH with binary file
rverify <st> <end> <file> [<file offset>] Verify RAM with binary file
term [baud rate]
Go to terminal mode, return to BootLdr with ^]
delay <msec>
Delay for specified number of milliseconds
pkt [type]
Set packet or simple protocol
evthdr [log id]
Read and display specified event log headers
evtrd [num entries] [log id] Read and display specified event log
evtclr [log id]
Clear the specified event log
evtdma 0|1
Set simple or decoded mode for DMA header log
read_id
Read module id structure
exit
Exit BootLdr
BootLdr>
The above commands are the most frequently used. For help on additional commands used mainly
for manufacturing testing type:
BootLdr> ? ?
BootLdr exit Command
The exit command exits the bootldr utility and returns to the DOS prompt.
BootLdr exec Command
The exec command allows a file of commands to be executed as a script. The exec command is
most often used to invoke the upgrade of onboard FLASH memory. This is detailed in the section
titled Upgrading Flash(below)
7-2
Series Six Parallel I/O Transmitter Module
GFK-1883