Download GFK-1883_SeriesSixPa..
Transcript
7 Real Time Consultants Pty Ltd (Proprietary Information) The bootldr utility will respond with a signon message and a prompt similar to the following: RTC Boot Monitor version 1.28, May 9 2002 Entering boot monitor, type help for help BootLdr> BootLdr help Command To get help on the available commands type: BootLdr>? The bootldr utility will respond with the following brief help on commands. BootLdr> ? Help ? or help Print this message reset Reset the target board boot [<baud>] Boot a target processor (optional baud) baud <baudrate> Set new baudrate exec Execute a procedure file md <start> [<end>] Memory display mm <start addr> Memory modify ferase <device> <sector>|<sector-sector>|all Erase FLASH sector(s) go <addr> <stack> [term] [baud] Execute from specified HEX address upload <dev> <st> <end> <file> Upload from target FLASH to binary file rupload <st> <end> <file> Upload from target RAM to binary file download <dev> <st> <end> <file> [<file offset>] Download bin file to tgt FLASH rdownload <st> <end> <file> [<file offset>] Download bin file to tgt RAM verify <dev> <st> <end> <file> [<file offset>] Verify FLASH with binary file rverify <st> <end> <file> [<file offset>] Verify RAM with binary file term [baud rate] Go to terminal mode, return to BootLdr with ^] delay <msec> Delay for specified number of milliseconds pkt [type] Set packet or simple protocol evthdr [log id] Read and display specified event log headers evtrd [num entries] [log id] Read and display specified event log evtclr [log id] Clear the specified event log evtdma 0|1 Set simple or decoded mode for DMA header log read_id Read module id structure exit Exit BootLdr BootLdr> The above commands are the most frequently used. For help on additional commands used mainly for manufacturing testing type: BootLdr> ? ? BootLdr exit Command The exit command exits the bootldr utility and returns to the DOS prompt. BootLdr exec Command The exec command allows a file of commands to be executed as a script. The exec command is most often used to invoke the upgrade of onboard FLASH memory. This is detailed in the section titled Upgrading Flash(below) 7-2 Series Six Parallel I/O Transmitter Module GFK-1883