Download Refrigerator control evaluation board

Transcript
CONCLUSION
Appendix 1 – Thermal Sensor Linearization
A NTC thermistor is a resistor whose value decreases when its temperature increases. The
thermal law is exponential, as presented in Equation 1.
Equation 1:
Rc(T) =
1
Ro. exp B.
T
1
To
To build a simple voltage sensor, it is better to linearize the temperature response using a constant resistor (R1) added in series with the NTC (Rc). This creates a voltage divider. The
voltage across R1 will follow the supply voltage (VDD ) according to the relationship below:
Equation 2:
Rc ( T)
Vs = ----------------------------- ⋅ V D D
R c( T) + R1
To make the relationship of Equation 2 to vary linearly, it's enough to ensure that the second
order derivative will be zero. Equation 3 gives the R1 value to ensure this condition.
d
Rc( T )
2.
dT
Equation 3:
R1 =
d
2
Rc( T )
2
Rc( T )
d T2
To linearize the voltage response of a M2020 12 k from EPCOS, between –30 and –5 °C, a 62
k Ω resistor should be chosen for R1. In this temperature range, Vs varies according to Equation 4, for a 5 V supply:
Equation 4:
Vs(T) = (T+50.1)/15.625
Figure 5 gives the variation of Vs and the linear value given by Equation 4 (refer to Vl), versus
the temperature sensed by the CTN.
13/20