Download HP 71910A - User`s Guide

Transcript
HP 70911A Ultra-Wide Bandwidth IF Section Inputs and Outputs
Video Output1
Characteristics
Connector
Bandwidth (03 dB)
Level
VSWR
Risetime
As selected by IF and video BW 2
0|1 Volts
<1.5:1
Connector4
Bandwidth (03 dB)
Group Delay Variation5
Rear panel SMB (m), 50
(nominal)
IF Bandwidth, as selected2
321.4 MHz Out1 , 3
VSWR
321.4 MHz Option Output1, 3
BNC (f), 50
(nominal)
<10 ns
5 ns, (preselector bypassed) 0 to 55 C
3 ns, (preselector bypassed) 20 to 30 C
<2.0:1
Connector
Bandwidth (03 dB)
VSWR
Rear panel SMB (m), 50
(nominal)
IF bandwidth, as selected2
Connector
Level
Bandwidth (03 dB)
Quadrature Error
I/Q Gain Imbalance
Total Harmonic Distortion
Spurious Emissions
Rise Time (10|90%)
Residual dc Oset
VSWR
BNC (f), 50
(nominal)
<2.0:1
I and Q Video Outputs (Option 004)1 , 3
60.5V
50 MHz (each channel)
6
1.25 dB
<1% (<040 dBc)
<070 dBc (non-harmonic)
10 ns
625 mV
<1.5:1
FM Video Output (Option 005)1 , 3
Connector
Level
VSWR
Pk-Pk Deviation
10 MHz
40 MHz
Modulation Frequency
Spurious Emissions
BNC (f), 50
(nominal)
60.5V
<1.5:1
FM Sensitivity
0.1V/MHz
0.025V/MHz
12 MHz (maximum)
035 dBm
Linearity
60.5%
60.15%
1 Characteristics except where noted.
2 Maximum IF bandwidth equals 100 MHz for center frequencies between 2.7 GHz and 26.5 GHz and
preselector in bypass. Preselector limits bandwidth to >36 MHz. For center frequency less than 2.9
GHz, HP 70910A lter limits bandwidth to >48 MHz. (A special option is available for wider lter.)
3 IF and demod outputs are inverted for center frequency <12.8 GHz due to \minus" harmonic mixing.
4 For access, disconnect from 321.4 MHz OPT IN.
5 Maximum peak-to-peak variation over 80% of the selected IF bandwidth.
Specifications and Characteristics
5-7