Download PulsePen User Manual

Tonometric Unit wTn1:
1.
2.
3.
On / Off button: keep pressed for about 1 sec.
Cap for battery replacement: pull away from the tonometer’s body. Extract the old battery
pushing it from the opposite side of the opening. Insert the new fresh battery never forcing and
following the specified polarity. Reinsert the cap in its final position pushing it until snap occurs.
Active part of the tonometric sensor.
ECG Unit wEc1:
1.
2.
3.
On / Off button: keep pressed for about 1 sec.
Cap for battery replacement: pull away from the unit’s body. Extract the old battery. Insert the
new fresh battery never forcing and following the specified polarity. Reinsert the cap in its final
position pushing it until snap occurs.
Patient cables connectors.
Signal Receiver Unit wRs1:
1.
Led signalling the operating mode. This Led blinks green when the software is not running or in
case the device is not correctly installed. This Led is fixed green during normal operations while
it’s red during reprogramming / update.
2