Download AdeptModules Instruction Handbook Volume 1, MV Controller
Transcript
Intended Use of the AdeptModules 1.4 Intended Use of the AdeptModules The installation and use of Adept products must comply with all safety instructions and warnings in this manual. Installation and use also must comply with all applicable European, international or local requirements and safety standards. The AdeptModules are intended for use in parts assembly and material handling for payloads less than 60kg (132 lbs). Refer to AdeptModules Instruction Handbook, Volume 2: Mechanical Assembly for configuration and related payloads. ! Warning: For safety reasons it is prohibited to make certain modifications to AdeptModules. See Section 1.5. The Adept MV controller, Adept PA-4 power chassis, and Signal Interface Box (SIB) are intended to be used as subassemblies of a complete industrial automation system. The controller and power chassis subassemblies must be installed inside a suitable enclosure and must not come into contact with liquids. The Adept equipment is not intended for use in any of the following situations: • In hazardous (explosive) atmospheres. • In mobile, portable, marine, or aircraft systems. • In life-support systems. • In residential installations. • In situations where the Adept equipment will be subject to extremes of heat or humidity. See specifications for allowable temperature and humidity ranges. ! Warning: The given instructions about operation, installation, and maintenance in this Instruction Handbook must be strictly observed. Nonintended use of an AdeptModules can: • cause injury to personnel. • damage the AdeptModules or other equipment. • reduce the system reliability and the performance of the system. All persons that install, commission, operate, or maintain the AdeptModules must: • have the necessary qualifications. • read and follow exactly the instructions in this Instruction Handbook. If there is any doubt concerning the application, ask Adept to determine if it is an intended use or not. AdeptModules Instructrion Handbook, Volume 1: Adept MV Controller Interface, Rev. A 21