Download Manual IMPACT20 EtherNet/IP

Manual
2.2
IMPACT20 EIP
Galvanic Isolation
To optimize electromagnetic compatibility and increase bus stability, the bus must be galvanically isolated from the remaining electronics.
Fig. 3: Impact20 modules – galvanic isolation
2.3
Electromagnetic Compatibility (EMC)
The units comply with the requirements of EC Directive 2004/108/EC "Electromagnetic Compatibility".
These units conform with Class A devices. They may cause radio interference in
residential areas. In this case, the operator may be required to implement suitable
countermeasures.
The devices described in this manual meet the relevant standards for electromagnetic compatibility in
themselves. However, this does not assume that their electromagnetic compatibility is also guaranteed
when built into a system.
For this reason, the user is urgently advised to observe the instructions below concerning installation
in accordance with EMC requirements.
Protection Against Electrostatic Discharge
The products described in this manual contain complete semiconductor components that may be destroyed or damaged by electrostatic discharge (ESD).
V1.1
16