Download "user manual"

Transcript
17.
In the JTAG Programmer window, choose Operations  Program from the menu bar, the Options
sub-window should appear. Select Erase Before Programming and Verify. Then click on the OK
button.
18.
When the download is finished, click on the OK button in the Operation Status sub-window to go back
to the JTAG Programmer window. Then, choose File  Exit. At the message sub-window prompt,
select Yes. In the Save As sub-window, click on Yes to save the JEDEC file and return to the Project
Manager window.
19
Using the jumper wires connect pin #74 on “HD2” to “T2”, Switch “S1” will be used as a clock
generator. Connect pin #72 on “HD2” to “T4”, switch “S2” will be used as a reset switch.
20.
Run the program on your PLDT-3 board and fill in the following truth-tables by using the “S1” switch for
clock and the LEDs for output, for resetting the circuit use switch “S2”.
Truth-Table for 3-bit Asynchronous Counter
LED
9
LED
10
LED
11
21
PULSE
SWITCH / S1