Download 2 System Configuration

User´s Manual
FK-C2
olt-control:
The command lets you GUI Control EPON OLT. Warning: for debug.
Syntax:
Parameter:
olt-control <0-1>
<0-1>: 0: Tk GUI not control, 1: Tk GUI can control
EXAMPLE:
Switch(olt)# olt-control 1
Switch(olt)#
olt-disable:
The command lets you Disable EPON OLT.
Syntax:
olt-disable <cr>
Parameter:
<cr>: means no parameter needed to type.
EXAMPLE:
Switch(olt)# olt-disable
Switch(olt)#
olt-enable:
The command lets you Enable EPON OLT.
Syntax:
olt-enable <cr>
Parameter:
<cr>: means no parameter needed to type.
EXAMPLE:
Switch(olt)# olt-enable
Switch(olt)#
olt-reset:
The command lets you Reset EPON OLT.
Syntax:
olt-reset <cr>
Parameter:
<cr>: means no parameter needed to type.
EXAMPLE:
Switch(olt)# olt-reset
Switch(olt)# +M25PXX : Init device with JEDEC ID 0xC22018.
Luton10 board detected (VSC7424 Rev. B).
RedBoot(tm) bootstrap and debug environment [ROMRAM]
Non-certified release, version 1_12-Vitesse - built 19:19:16, Apr 18 2011
Copyright (C) 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Free Software Foundation, Inc.
RedBoot is free software, covered by the eCos license, derived from the
GNU General Public License. You are welcome to change it and/or distribute
copies of it under certain conditions. Under the license terms, RedBoot's
source code and full license terms must have been made available to you.
Redboot comes with ABSOLUTELY NO WARRANTY.
Platform: VCore-III (MIPS32 24KEc) LUTON26
RAM: 0x80000000-0x84000000 [0x80021198-0x83fe1000 available]
FLASH: 0x40000000-0x40ffffff, 256 x 0x10000 blocks
== Executing boot script in 3.000 seconds - enter ^C to abort
RedBoot> fis load -d managed
Image loaded from 0x80040000-0x806c04b8
RedBoot> go
Username:
160