Download Manual

NAS System
Serial Port
UPS
Enable – Use the option to enable or disable UPS support for serial port.
Serial Port – Use this option to select serial port option (com1 or USB).
Note: In NAS models with com2 serial port, com2 is reserved for SES
use.
Service – Use this option to select the type of UPS, whether UPS (smart) or
Dumb UPS.
UPS Vendor – Use this option to select the UPS vendor. Currently, only APC
and Beam-Tech UPS models are supported.
Cable Model – Use this option to select the UPS cable type. Options are:
simple, smart, ether, and usb.
Shutdown Delay (Min) – Use this option to set the delay time in minutes
before UPS shutdown.
Reset – Use this button to undo or clear any changes made.
Apply – Use this button to save the changes made.
90
User Manual