Download Gauger420 User Manual - SOLID APPLIED TECHNOLOGIES LTD

Notices and safety guidelines
This manual is a detailed technical guide for Gauger420 level sensor. Some information in this manual
refers to GaugerGSM, GaugerGPS and Gauger485 sensors and cannot be applied to other Gauger
models.
The manual is published under the following conditions and restrictions:
 Some features are firmware, hardware, model or version dependent. These features are described
in the user manual but will not apply to all Gauger sensors. In case of doubt, the user should verify
which features apply.
 Information included in this manual is subject to change without notice. Information in the manual
may contain inaccuracies. Specifications are based on laboratory test results which are performed
under tightly controlled environment. Field performance may vary from laboratory test results. We
always welcome suggestions and recommendations from the users of our manuals.
 Gauger sensors must be installed, connected and operated in accordance with the instructions of
this manual and with certification requirements as applicable. Specific local regulations may also
apply.
 Installation and use of Gauger models that are rated for use in explosive atmosphere must closely
follow the instructions detailed in the proper section for this model type.
 Do not open or disassemble Gauger sensors except as required for electrical connections.
 Any type of modifications and repairs are permissible only upon the manufacturer or re-seller
written approval and by pre-qualified personal. Never reuse defective parts.
 The manual contains proprietary information belonging to Solid Applied Technologies Ltd. The
information is published solely for the purpose of assisting authorized users of Gauger level sensors.
 No part of this manual may be used for any other purpose, or disclosed to any person or firm, or
reproduced by any means, without the prior written permission of Solid Applied Technologies Ltd.
 The text and graphics in this manual are for the purpose of illustration and reference only.
 All company names, brand products and service names that may appear in this manual are
trademarks or registered trademarks of their respective holders.
 Solid Applied Technologies shall not be liable for loss or damage caused by the use of this manual or
of products described in the manual. Solid Applied Technologies sole warranty is that products sold
by the company shall be free of defects in material and in workmanship for a period of 12 months.
Date
May 2014
Revision
2.04
Software version
Gauger420 3.12
Part number
Gauger420
_____________________________________________________________________________________
Gauger420 – User Manual
page 2 of 126
May 2014 Rev 2.04