Download RxT 10GE User`s Manual

RxT 10GE User's Manual
RFC2544 Back-to-Back Testing Notes
At the start of the test, the RxT 10GE will send frames back-to-back for the specified
duration.
• If the test runs without losing frames, the duration will be increased and the
test redone until frames are lost or until the maximum duration is reached.
• If frames are lost, the duration will be reduced until no frames are lost.
• This cycle will continue until the specified resolution is reached.
• Once completed, this is counted as one repetition; the test is then repeated,
starting at the original duration, for the number of repetitions specified.
Where do you want to go next?
RFC2544
RFC2544
RFC2544
RFC2544
RFC2544
index
Back-to-Back Setup
Throughput Test Setup
NE Stress Test Configuration
Applications
Summary Results
RFC2544 Throughput Latency Setup
Select RFC2544/NE Test as the test type on the RFC2544 Signal setup window to
perform RFC-2544 tests.
Throughput/(Quick) Latency - NE
Parameter
Options
Details
Duration
Time,
Frames
Set how measurements will be taken.
TIME: Base measurements on a length of time.
FRAMES: Base measurements on a number of
frames
Duration = Frames
Frames
Time
Start Rate
10/100M:
N/A
• GigE
Options:
10,0001,000,000
• 10GE
Options:
10,00010,000,00
0
4-60 seconds
.01-100%
Stop Rate
01-100%
104
•
Duration = Time
Set the rate at which frames will begin being
transmitted.
• 100% is a good starting rate for a standard
RFC test, recommended in RFC 2544.
• For NE testing, select the rate applicable to
your setup.
Set the rate at which frames will stop being
transmitted. 100% is typical.