Download User Manual

Sonel Analysis 2 Operating manual
4 Data Analysis
The analysis block allows the user to read data collected by the analyzer during the recording,
view numerical data and graphical visualization. The user may generate reports that in a clear
manner describe the tested system.
4.1
Reading data from the analyzer
PQM-702, PQM-703, PQM-710 and PQM-711
analyzers use the built-in mass storage mode to accelerate the readout of data via the USB
connection. This mode is used when the amount of data to be downloaded exceeds 1 MB. If
the amount of data is below that limit, a standard (slower) communication mode is used. Other
analyzers use only standard communication mode.
Note
When other, additional windows are also opened for displaying on-going (live)
data from the analyzer (e.g. Live mode or Control), the standard (slower)
communication mode is used for data download. Before pressing Read Data
button, close these additional windows in order to use the high-speed data
reading mode.
After selecting analysis from the upper menu or clicking Analysis icon, when no analyzerprogram connection is established, a standard connection procedure is launched to connect the
analyzer and the program (sec. 1.4).
After correct connecting the analyzer to a PC, a window is displayed - as shown in Fig. 48 and
data may be selected for downloading and further analysis. To do this, select the measurement
points from which you want to download the data. On the right side of the bar representing the
amount of stored data, the actual amount of data is displayed.
Fig. 48. Selecting data for read-out.
62