Download i3E Manual

To check or change the ID on the i³E, press the system menu key.
The first item in the menu is Set Networks. Pressing Enter allows the ID of the unit to be viewed or
modified.
To change the Target ID of i³E, use the Controller | Set Target Network ID dialog.
Communicating via MJ1 Serial Port
Start by configuring i³Configurator to use the correct communications port. This can be done using the
Tools | Options | Communication Port dialog in i³Configurator.
Next, connect the PC’s serial port to the port labelled MJ1 on the i³E.
If communications are successful, the target indicator should show the mode of the controller Target:
yy(R) as shown in the status section above.
If the controller is not communicating, it may be required to set the target ID of the controller in
i³Configurator or on the unit. The Target ID allows directing communications to a particular unit when
multiple units are connected via iCAN network. Units without iCAN network ports respond to any
network ID and do not require the ID to be configured.
To check or change the ID on the i³E, press the System Button to enter the system menu. The first item in
the menu is Set Network ID.
Pressing Enter allows the ID of the unit to be viewed or modified.
To change the Target ID of i³, use the Controller | Set Target Network ID dialog.
73
I3E-MAN0114R0
www.imopc.com